Sorry that I ask this question here, but I've tried everything and nothing works.
I am working with a carrier on a transport surface that has walls on both sides. I link multiple of these transport surfaces end to end (with a tiny air gap) and make the carrier move in a straight line.
But after a few conveyors, my carrier rotates around Z and is stuck.
When I look up close, I can see that my carrier clipped through the wall. Both have box colliders and are set to continuous dynamic collision detection. The corners of my carrier have a cylinder with a convex mesh collider attached.
You can see my picture below, I hope it is clear, but it is a top down view of my carrier clipping though the wall. (You can see the collider of the wall and carrier highlighted in green.
I really hope you can help me!
with kind regards,
Customer support service by UserEcho