We are sorry, our new doc page is here:

https://doc.realvirtual.io

Hi,

Hi Alexander,

which realvirtual version do you use in Unity6? 

Best regards
Christin

Hi Alexander,

we are checking this - we know that there has been an issue with the new Unity 6 Physics. Will keep you updated.

Best regards
Thomas 

Hallo Nico,

ehrlicherweise haben wir schon wie verrückt gesucht, die Gründe der Abweichung zu finden und aus der Not das Set Correction eingeführt (die Inverse Kinematik Mathematik selbst stammt nicht von uns). Aktuell gibt es keinen Weg drumrum, bei Gelegenheit machen wir aber nochmals einen DeppDive. Den Vorgang zu automatisieren müsste möglich sein, Du könntest Dir hier selbst ein Script schreiben und die Methode des Buttons mehrmals aufrufen.

Gruß

Thomas

I don't think that you will get simulation under 4ms. This would mean to set the Unity Physics at values around 1ms and this will take a lot of computation load and won't work on bigger systems. Fastest Interface schould be via Simit, followed by PLCSimAcvanced but you would need to set Simit cycle times to low values. 

Hi Ahmo,these are likely Profibus/Profinet interfaces. There are three possible approaches you can take:

1️⃣ Write Directly to DB/EA Areas & Implement Custom Behavior Models

• This allows you to fully control the behavior but requires a lot of effort, especially for frequency converters, as you’d need to model their behavior in detail.

2️⃣ Bridge the Simulation on the PLC & Use Simplified Behavior Models in realvirtual.io

• Instead of fully implementing the detailed logic, you could introduce a “Simulation Mode” on the PLC and use simplified drive behavior models on realvirtual.io (e.g., basic current response models). This reduces complexity while maintaining a functional simulation.

3️⃣ Use Siemens' Behavior Models (Requires Simit & PLCSimAdvanced)

• Siemens provides dedicated behavior models for such cases, but this requires a Simit license and potentially PLCSimAdvanced or a Simulation Unit running alongside realvirtual.io. This is typically Siemens’ recommended approach.

Each option has its trade-offs in terms of complexity, cost, and realism.

Just for making sure that the setting is correct. Put/Get in PLC is enabled and the "virtual Network Interface" - don't know the exact name in PLCSimAdvanced is activated? Is any communication possible or is only DB Access not working?

I think we need to check on your computer. Do you have a time slot tomorrow morning?

ok thanks, will need to check the enabling in run mode.